Starlink and solar jack Starlink jack only D-Pillar box with included blank plug Installed into D-Pillar Installed into D-Pillar Starlink Mini Installation You can read our Starlink Mini Install Guide to learn more. Here’s what we cover: Powering & wiring; Roof installation; Ground deployment (using the D-pillar box). Starlink Mini Install: Power, Wiring, & Mounting to our VanBuild Journal Van #2 | Internet, Connectivity & Electronicsfaroutride.com/starlink Connectors Installation Route the wires first and insert your connector in one of the 30mm cutouts (or blank plug, etc.): Tighten the screw in the back and that’s it! Van Installation The entry box fits the driver or passenger side. Driver side is shown below. Under the D-Pillar, grab an edge of the rubber cover: Pull down to remove the cover: Route the wires (Starlink Mini, Solar, etc.) through the D-Pillar cutout: Grab and pull the wires from inside the van: We recommend using weatherproof connectors (such as Ancor Insulated Heat Shrink Disconnects): Snap the Entry Box into the D-Pillar. You can gently press the top edges (front & back) to make it easier: That’s it! No need to seal the edges, it’s ready to go! (To remove the entry box, gently squeeze the front & back edges, then pull down.) Specifications Outside Dimensions: 5in x 3.5in x 3in (127mm x 89mm x 76mm). Material: Polycarbonate/PETG. Temperature Resistance: Up to 221F (105°C). Shipping Ships From: British Columbia, Canada. Carrier: Canada Post / USPS. Cost: Actual carrier shipping rate calculated at checkout. You can combine other items from our Store to save on shipping. Warranty, Returns & Refunds Warranty: If there is an issue or manufacturing defect, we’ll be happy to send you another free of charge! �� “Crash” replacement: if the Entry Box breaks during normal usage (rock, snow bank, etc.), we offer 70% discount on a new one (plus shipping). All we ask is a photo of the damaged box. We still think the box should be the weakest link to prevent damage to the van structure. Return & Refund: See our Return and Refund Policy. ABOUT THIS PRODUCT Do It Yourself. We wanted a solution to connect a Starlink Mini and portable solar panels, so we made one. This is an homemade product. Each part is individually 3D printed and assembled by us. This is not a mass-produced product. This is a crafted, hand-made product. Low Volume. We created this product for our own needs, to make just a few units. There is no way for us to ramp up the production and lower the price, unless we take it to injection molding manufacturing but that’s a whole another level we’re not considering at the moment. Also Available 15A Noco Shore Power Inlet Entry Box 30A Shore Power Inlet Entry Box Blank/DIY Entry Box
